Precautions during installation of R series inclined gear:

The 1, inclined gear hard tooth reduction box shall be installed under a flat and solid base, the bottom bolts must be firm, shock and oil from the drain tank shall be excluded, and the cooling air circulates smoothly.The foundation is not reliable, causing vibration, noise and causing damage to bearing and gears.When the transmission coupling has protrusion or adopts gear and sprocket transmission, and the output shaft bears a large radial load, the reinforcing type should be selected.
2, follows the specified installation device to ensure that the staff can be easily close to the oil gauge, air plugs and oil drain plugs.After the installation is in place, the accuracy of the installation position shall be comprehensively checked in order, the reliability of each fastener compaction, and the flexible rotation shall be able after installation.The gear reducer is lubricated by grease tank. Then the user shall remove the screw plug of the vent and replace the vent plug before operation.According to the different installation position, and open the oil level plug screw to check the height of the oil level line, refueling from the oil level plug until the lubricating oil from the oil level plug screw hole overflow, unscrew the oil level plug to determine, the no-load test operation, the time shall not be less than 2 hours.Now we produce the reducer that can directly use the oil meter to read the oil volume, which is more convenient.The operation shall be smooth without shock, vibration, noise and oil leakage, and any abnormality shall be eliminated in time.The oil level shall be checked again after a certain period to prevent possible leakage of the casing, such as the ambient temperature is too high or too low, the lubricant brand number can be changed.
When 3, alls the reducer, the error of the transmission center axis shall not be greater than the compensation of the coupling used.Good pair can extend the service life, and obtain the ideal transmission efficiency.

The 4, uses no hammer tapping on the output shaft to press it in with the bolt using the assembly clamp and the internal thread of the shaft end, otherwise damage to the internal parts of the reducer may be caused.It is best not to use steel fixed coupling, because of improper installation of this coupling, will cause unnecessary external load, resulting in early damage to the bearing, and even serious output shaft fracture.
When assembling the motor of the 5, inclined gear hard gear box, butter shall be applied to the hole wall and keyhole in the head of the worm head to avoid too tight assembly and long rust of the shaft hole;
These five points seem simple, easy to operate, but there are often a lot of users will ignore this step, often some small errors in the operation, you can once again read the above content carefully, in order to use in the future.